XMAX V-ONE + OPERATION GUIDE

1.Remove XMAX V-ONE +'s glass Mouthpiece, exposing the heating element.

2.Use the dab tool to put a small amount of concentrate or essential oil into the heating element, then put back the glass Mouthpiece.

3.Click the button 5 times in quick succession to turn XMAX V-ONE + on/off. Then the LED light will flash 3 times.

4.Press the button and then inhale slowly and deeply from the mouthpiece.

LOW POWER: The light will flash 10 times and the device will automatically shut off.

1.To protect and extend the battery, It is recommended to charge your XMAX V-ONE+ vapor pen at least 6 hours before initial use.

2.When plug in, the red light will be on all the time.

3.The red light will goes off when battery is fully charged.

Warning: XMAX V-ONE+ CANNOT BE USED WHILE CHARGING. Otherwise it will be dangerous. After using the XMAX V-ONE+ vapor pen or charging, allow them to cool down before placing them in storage. Please store them in a dry place protected against the effects of weather and out of the reach of children or unqualified persons.

1.TO CLEAN YOUR HEATING COIL: While your device is turned off, first unscrew your V-ONE+ heating coil from its corresponding base. You may either use a damp cotton swab to clean your mouthpiece and inside of your heating coil or directly submerge the two pieces(Mouthpiece and Heating Coil) in isopropyl alcohol. Once clean allow both pieces to air dry or dry off with a soft cloth or towel.

2.TO REPLACE YOUR HEATING COIL: Simply remove your mouthpiece, and unscrew the current heating coil from the base of the V-ONE+ Once the used heating coil has been removed you may now install the replacement by screwing it directly back into the base. Reinstall mouthpiece.

DO NOT SUBMERGE OR CLEAN BATTERY WITH WATER OR ISOPROPYL ALCOHOL

Always detach V-ONE+ heating coil from battery prior to cleaning. (DO NOT TOUCH THE HEATING ELEMENT IMMEDIATELY AFTER USE)