1.Remove XMAX Vital's mouthpiece, exposing the heating chamber.
2.Always fill the chamber with moderate ground Botanicals, DO NOT compress the plant material too much so that the airflow is not unnecessarily impeded. Then insert mouthpiece back onto the heating chamber.
3.Hold the Power Button for 3 Seconds to turn on the XMAX Vital and It will begin to heat up at once under the default settings. The "
" will keep blinking during the heat-up stage. Wait for the "
" become solid and You are ready to puff until the "
" stops blinking.
4.Setting temperature, press the "+" to increase temperature, press the "-" to decrease temperature. (XMAX Vital will automatically remember your last setting when restart.)
" will solid once the selected temperature reaches. Then inhale slowly and deeply from the mouthpiece till the OLED screen off.
6.Temperature switch over between Fahrenheit and Celsius. Hold the Power button and "-" button at the same time for 2 seconds.
7.Timers switch over between 5 minutes and 10 minutes. Hold the Power button and "+" button at the same time for 2 seconds.
A.To protect and extend the battery, It is recommend your XMAX Vital be charged with wall adapter for at least 6 hours before its first use.
B.When Charging, the OELD screen will light on,The battery icon will change to show battery charging condition. The icon gauge will be full when battery fully charged. The XMAX Vital will automatically power off if no operation within 60 seconds after fully charged.
C.After using the XMAX Vital vaporizer and power adapter, allow them to cool down before storage. Store the Vital vaporizer in a dry and cool place to protect against the effects of weather and out of reach of children or unqualified persons.
A.To maintain the XMAX Vital, it is recommended to clean the chamber and the mouthpiece after every use.
B.Clean the rubber mouthpiece, use a cotton swab and wipe the inner part of the rubber mouthpiece then wipe again with a damp paper towel.
C.Clean the filter, after using, use the brush tool to gently clean the filter. Fora deeper clean, use your hands or damp paper towel to gently clean the filter with a mixture of soap and water.
D.Clean ceramic heating chamber,deactivate the XMAX Vital by locking it. Make sure the vaporizer has not been used for at least 30minutes and is completely cooled off use the clean brush to gently clean the walls of the heating chamber. You may use small wipes to clean out any leftover particles.
DO NOT clean the whole device with water or submerge.
DO NOT inject any liquid or oil into the ceramic chamber.